TR800-F1 ( Frequency 482-500/614-632MHZ ) UHF Two-Channel Wireless Beltpack
- Version with XLR5F (Some RTS device)
ON/Off & Volume Control
Turns the beltpack power on and controls head set volume Wireless Talk Around (WTA)
When pressed, the user's audio is disconnected from the wired intercom, auxiliary
input/output and the base station's local headset Other beltpack users, on that audio
channel, can hear the user as normal
Stage Announce (SA)
When pressed, the user's audio is routed to the stage announce connector on the back
of the base station The user also loses their sidetone as an indication that stage
announce is activated The other wireless beltpacks and wired users do not hear the
user's audio The button is non-latching and activates the nearby red LED
Audio Channel Select Button. Allows user to select either audio channel A or B
Bat/Overmod Light (BAT/OM)
Light will flash once when unit is turned on if the battery is good If the light stays
on, battery is low If the light does not flash, battery is dead A normal microphone
gain setting will cause the LED to flash at the beginning of most words at normal
speech levels If the gain is too high, the LED will be red during the complete word at
normal speech levels
Talk Light
LED is on when the talk button, SA or WTA is active
Talk Button
Press to enable the audio path from the local headset microphone The LED, #6, will
turn red when enabled A quick press and release latches the talk function, unless
latching has been disabled Holding the button for over � a second will cause the audio
path to be enabled only for as long as the button is held If the talk function is
latched on, pressing the talk button again will turn it off
Specifications
Antenna : � Wave (supplied), Screw type, Replaceable TX and RX
Binaural : No
Color : Black
Current Draw : 140 mA Push-to-Talk, Talk On
Depth : 42mm)
Distortion : < 1 % at full deviation
FCC ID : B5DM518 (TX 470-608 MHz), B5DM515 (TX 614-746 MHz)
Frequency Resp : 300Hz-8kHz
Function : User Station Portable
Height : 128mm
IF Selectivity : 3dB at 230kHz
Image Rejection : 70dB or better
Local Headset Output : 40mW output into 600W 1% distortion
Microphone Input Sensitivity : 7mV
Power Requirements : 6 "AA" Cells Alkaline NiMH optional
RF Freq.Range : 470-608MHz, 614-740MHz in 18 MHz TX and RX bands
RF Freq.Stability : 001 %
RF Sensitivity : < 07 �V for 12 dB SINAD
Squelch Quieting : 90 dB
Squelch Threshold : 20 dB SINAD About 10 �V
Storage Temperature: -20�C to 55�C
Type : Dual Conversion Super heterodyne, Synthesized, FM, 712 channels
Weight : 453g
Width : 96mm
Variant Frequency available
TR800-A2 518-536/632-650MHz
TR800-B4 536-554/668-686MHz
TR800-C6 554-572/704-722MHz
TR800-F1 482-500/614-632MHz
TR800-F3 482-500/650-668MHz
TR800-H1 500-518/614-632MHz
TR800-H3 500-518/650-668MHz
Accessories Available
BC-800NME Euro1 bay charger w/switching power supply, Euro cord, NiMH pack
BC-800NM4E Euro4 bay charger w/switching power supply, 4 NiMH battery packs,Euro cord
BP-700 Alkaline battery holder
BPA1/xxx 1/4 Wave beltpack antenna (multiple frequency ranges)
SBC-1 Swivel beltclip
TRH-2 Heavy duty leather swivel holster with belt loop for TR-700/TR-800/TR-80N
