LEN LTD L3GS01 3G SDI Splitter

Overview

The LEN 3G Splitter is suitable for additional monitor feeds; remote camera locations and situations where size and weight are critical factors – such as racing cars, bikes and other sporting and research applications.

Each is built into an ABS enclosure fitted with three female BNC connectors.

Features

Miniature passive Splitter – no power required
Broadcast quality signal up to 3 GHz
Size 45 x 30 x 15 mm – weight less than 30 gm
Ideal for permanent and temporary installations

Description / Details

Two (or more) 3G Splitters can be used in series to provide up to 8 individual feeds over shorter distances. The actual distance depends on original signal strength and cable type.

Further Notes

To guarantee the specified performance the input should be fed with a source impedance of 75 ohms and both outputs should be terminated with 75 ohms. Therefore, if an output cable is not present, a 75 ohm termination should be fitted. This should be specified to operate over the full SDI bandwidth in use.

However, typical feedback from End Users is that not terminating an unused output does not cause significant reduction in performance.

Technical Data

Impedance : 75 Ohms
Insertion Loss : 3.4dB
Amplitude roll-off : <0.2 dB to 360 MHz
<1.0 dB to 1485 Mhz
< dB to 3 GHz

Return Loss (input) : >15 dB 0.1 to 1485 MHz (with both outputs terminated)

Drive Capability : > 70 metres (depends on cable quality)

Isolation between Out Ports: 35dB @ 360MHz / 16dB @ 1485Mhz / @ 3Ghz

Enclosure : ABS box, 45 x 30 x 15 mm (excluding connectors)

Weight : 30gr